Approved list of backflow prevention assemblies
Backflow prevention assemblies
, and/or methods
are utilized on water supply piping to protect against hazards caused by backpressure or back-siphonage conditions that could cause pollutants or contaminants to backflow into the public water supply and/or the water user's system.
Under current Oregon Administrative Rule 333-061-0070
(PDF), Department-approved testable
backflow prevention assemblies
shall be assemblies approved by the University of Southern California (USC) Foundation for Cross Connection Control and Hydraulic Research
. Membership to the Foundation is required for access to this list of approved assemblies. The Department has limited permission from USC to provide this reformatted list by mail to public water systems and water system consultants working within Oregon. New assemblies approved by USC are available on cumulative addenda prepared throughout the year.
- For a copy of the entire Approved Backflow Prevention Assemblies List or the most recent addendum, please contact the Program Coordinator.
Assembly approvals listed are individually dated and valid within 3 years of the current date, specific to manufacturers, model numbers, piping sizes, installation orientations, and attached shutoff valves. Detector type assemblies are additionally listed with the specific approved bypass meter(s). The list includes the four general types of testable backflow prevention assemblies:
- Reduced Pressure principle backflow prevention assemblies (RP) and the related Reduced Pressure principle-Detector backflow prevention Assemblies (RPDA),
- Double Check valve backflow prevention assemblies (DC) and the related Double Check-Detector backflow prevention Assemblies (DCDA),
- Pressure Vacuum Breaker back-siphonage prevention assemblies (PVB), and
- Spill resistant pressure Vacuum Breaker back-siphonage prevention assemblies (SVB).
backflow prevention devices
such as Atmospheric Vacuum Breakers (AVB) are approved under Oregon Plumbing Specialty Code as listed with the ASSE Seal Program. The American Society of Sanitary Engineering (ASSE)
Seal Program lists approved manufacturers and uses, for example, the standard designation of 1001 for pipe applied AVB (example: irrigation systems) and 1011 for hose-type connection AVB.
An approved air gap
is a method
of backflow prevention that means the physical separation between the end of the water supply pipe (example: faucet) and an open vessel (example: sink). Approved air gaps are generally at least twice the diameter of the supply piping, in no case less than 1 inch (2.54 cm) and are in accord with Oregon Plumbing Specialty Code.
For more information about the Oregon Plumbing Specialty Code, contact Building Codes Division Plumbing Program
. For information about fire sprinkler code, contact the Oregon Fire Marshal office